Finshed Product!

From: "Nate \"Okie Smoke\" Sharber" <Okie_Smoke@hotmail.com>

Subject: Finshed Product!

Date: Sat, 11 May 2002 21:35:40 -0400

Other than a few things like re-routing the clutch cable, wiring wraps,
license plate frame and mounting the Jardine's, the project is finished.
This has truly been a VROC project and it would take me forever to thank
everyone who contributed parts or technical expertise.  So let me just say
"Thanks All!"  A few of the changes made, include a F&S V-Force II
windshield (minus cheesy ~V~ sticker), Classic rear fender, 1500 Classic
handlebars, Kuryakyn Iso-Grips, Thunder SSK kit, polished/modified
carburetor, SS cables, chrome wide-blade levers, Mustang WN and fender bib.
A special item is the low-buck license plate mount.  It is molded out of ABS
plastic and comes in a black or primer finish.  This mount is made by a guy
in Norman, OK and was actually developed for HDs.  However, it is a perfect
fit using the two lower holes!  I might add a thin rubber gasket later, but
it really follows the contour of the fender well without it.  Take a look at
the pictures and let me know what you think!

Nate "Okie Smoke" Sharber
VROC #6745 Bridge Creek, OK
1998 800A With whole lotta stuff on it!
http://home.talkcity.com/SparkplugSt/okie_smoke/